EN 
English
Español
عربى
Product Consultation
Your email address will not be published. Required fields are marked *
A TCCS wire is one of many wiring connections in a car that sends information to the engine control unit (ECU), letting it know that the brake pedal has been pressed. This allows the ECU to unlock the torque converter clutch. If this function is not functioning properly, the car might display a P0741 code. This code may indicate a problem with the TCCS solenoid, which could be due to a short in the electrical circuit or a worn out clutch. In either case, it is important to diagnose and fix this issue before proceeding with any other repairs.
TCCS wires are used to communicate with the ECU and transmit information such as the status of the clutch, throttle position, transmission shift points, and other diagnostic information. These wires also carry power to the engine and other components. This type of wiring is essential for the functionality of a vehicle and is used in both domestic and imported vehicles. In addition to being used for communication purposes, TCCS wires are also responsible for controlling several other functions such as the traction motors and a power steering system.
The most common TCCS wire is the BLUE wire, which is connected to a decoder's positive voltage source. This supply is usually 1.5V less than the DC track voltage and can power lighting effects and other NMRA-standard decoder outputs. Typically, a single BLUE wire can be connected to a number of lights and other functions. In most cases, the light function connections on a DCC-compatible decoder are wired to a centralized point called a function matrix or a masked address. Refer to your decoder literature, a wiring diagram, or the silk screen on the board for LED connection details.
The Layer 2 switching TCC function performs the same type of Layer 2 forwarding that you perform on a regular logical interface, but it swaps Layer 2 headers rather than performing additional processing. For example, TCC does not perform Layer 2 header checksums or TTL decrementing. You configure TCC by creating a layer-2 switching TCC cross-connect between two logical interfaces on the router acting as the switch. For each pair of logical interfaces that you connect, you specify the interface name and a connection name. The connection name must match the logical unit number that is configured in the layer-2 switching TCC configuration.
Tinned Copper Clad Steel Wire (T-CCS Wire)
Tinned copper-clad steel wire (T-CCS wire) is what we often call "CP" wire. Tinned copper-clad steel wire is a new type of composite material, which is made of low carbon steel with excellent quality as the core wire, evenly coated with an oxygen-free copper layer by mechanical method, and then plated with a pure tin layer.
Due to the high material purity of each coating, the compactness between the copper coating and tin coating is good. It can be divided into soft state (a) and hard state (H).
